Maintenance And Care; Disposal Information; Declaration Of Conformity - Flex CI 11 18.0 Notice D'instruction D'origine

NOTE
After approx..5 minutes of inactivity the tool
will automatically turn off.
Use the Digital Pressure Gauge in
the High-Volume Mode
(see figure K)
■ Turn the digital pressure gauge on by
pushing the power button (6). The working
mode (27) will default to the high-pressure
mode. Press the mode button (5) to switch
to the high-volume mode (31).
■ To start or pause the inflation or deflation,
press the start/pause button.
NOTE
Because the target pressure cannot be set in
the high volume mode, there is no pressure
related automatic shutoff.
LED Work Lights
■ To turn the LED work lights on, first power
on the dual function inflator by pressing
the power button, then press the LED On/
Off Button(7).
■ Press the LED On/Off button (7) again to
turn off the LED work lights.

Maintenance and care

WARNING!
Remove the battery before carrying out any
work on the power tool.
Cleaning
■ Clean the power tool regularly. Frequency
of cleaning is dependent on the material
and duration of use.
■ Regularly blow out the housing interior
and motor with dry compressed air.
Spare parts and accessories
For other accessories, see the manufacturer's
catalogues. Exploded drawings and spare-
part lists can be found on our homepage:
www.flex-tools.com

Disposal information

WARNING!
Render redundant power tools unusable:
Mains operated power tool by removing
the power cord,
16
Battery operated power tool by removing
the battery.
EU countries only
Do not throw electric power tools into
the household waste!
In accordance with the European Directive
2012/19/EU on Waste Electrical and
Electronic
Equipment and transposition into national law
used electric power tools must be collected
separately and recycled in an environmentally
friendly manner.
Raw material recovery instead of
waste disposal.
Device, accessories and packaging should
be recycled in an environmentally friendly
manner. Plastic parts are identified for
recycling according to material type.
WARNING!
Do not throw batteries into the household
waste, fire or water. Do not open used
batteries.
EU countries only:
In accordance with Directive 2006/66/EC
defective or used batteries must be recycled.
NOTE
Please ask your dealer about disposal
options!

-Declaration of Conformity

We declare under our sole responsibility
that the product described under "Technical
specifications" conforms to the following
standards or normative documents:
EN 60335-1 in accordance with the
regulations of the directives 2014/30/EU,
2006/42/EC, 2011/65/EU.
Responsible for technical documents:
FLEX-Elektrowerkzeuge GmbH, R & D
Bahnhofstrasse 15, D-71711 Steinheim/Murr
Peter Lameli
Technical Head
01.12.2020; FLEX-Elektrowerkzeuge GmbH
Bahnhofstrasse 15, D-71711 Steinheim/Murr
CI 11 18.0
Klaus Peter Weinper
Head of Quality
Department (QD)