Maintenance And Care - Flex BME 14-3 L Notice D'instruction D'origine

Preselecting the speed
The adjusting wheel enables the operating
speed to be continuously adapted to the
material requirements.
Speed burnishing
attachment
[r.p.m.]
1 1000
2 1500
3 2000
4 2500
5 3000
6 3500

Maintenance and care

WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Cleaning
WARNING!
If metals are ground or cut over a prolonged
period, conductive dust may become
deposited inside the housing. Impairment of
the protective insulation! Operate the power
tool via a residual-current-operated circuit-
breaker (tripping current 30 mA).
Regularly clean the power tool and ventila-

tion slots. Frequency of cleaning is depen-
dent on the material and duration of use.
Regularly blow out the housing interior and

motor with dry compressed air.
26
Belt speed belt
sander attachment
[m/s]
3,5
4,8
6,1
7,4
8,7
10,0
Carbon brushes
The drive unit is fitted with cut-off carbon
brushes. When the cut-off carbon brushes
reach their wear limit, the power tool switches
off automatically.
NOTE
Use only original parts supplied by the
manufacturer for replacement purposes.
If non-original parts are used, the guarantee
obligations of the manufacturer will be
deemed null and void.
When the power tool is being used, the car-
bon brushes can be seen sparking through
the rear air inlet apertures. If the carbon
brushes are sparking excessively, switch off
the power tool immediately. Take the drive
unit to a customer service centre authorised
by the manufacturer.
Gears
NOTE
Do not loosen the screws on the gear head
during the warranty period. Non-compliance
will deem the guarantee obligations of the
manufacturer null and void.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
Replacing wearing parts
During the operating time of the belt sander
the felt pads on the swing arm wear out.
Spare parts are available from the
manufacturer or your dealer.
TRINOXFLEX