HAKO Hakomatic B 30 Manuel Technique page 41

6. Têtes de brosses
6.3.4 Brush Deck 50 cm (Cylindrical brush deck)
For the 50 cm Cylindrical brush deck, switch S4 of the 4-pin DIP-swich on control board A1, must
be adjusted to "1" - ON. This deactivates the brush release switch on the dash board.
The current consumption of the brush motor with installed brushes, but without floor contact,
should be less than 5A.
Rotating direction of the brushes, seen from the driven side:
- front brush - counter clockwise - front brush - counter clockwise
- rear brush - clockwise
Fig. 6/14
Foil 41