Assembly Instructions - Seating The Child On The Carrier - Polisport Koolah CFS Mode D'emploi

04. ASSEMBLY INSTRUCTIONS
EN
SEATING THE CHILD ON THE CARRIER
17
B3
B
B2
B1
Before placing the child in the carrier make sure the child is helmeted and properly prepared for the ride (NOTE: section 06
and 07 of this manual). To place the child in the carrier, start by fully extend the safety harness (B) and sliding the strap
adjuster (B2). Then proceed to open the safety buckle (B1) of the retention system harness (B) and press the three buttons of
the safety buckle (B1) as indicated. As the child grows you can adjust the height of the belt on the retention system
adjustment hole (B3) as it will adapt better to the child's height, promoting a safer and more comfortable retention. NOTE:
Before any journey, always check that the child is secured and that the belt is snug but not so tight that it hurts the child. We
recommend that the child's helmet is put on after the belt is adjusted.
9
A
E
To adjust the height of the footrest (E) to fit the child, release the footrest (E) from the child carrier (A) by pressing the two
clips and lift the footrest as indicated in the picture (it may be necessary to apply some pressure to the clips).
7