Flame Adjustment; Cleaning Your Appliance - BLAZE BLZ-1PRO-PRT LP Mode D'emploi

Before cooking with your appliance for the first time, burn off any foreign matter and rid the unit of any odors by burning the
main burners only on HIGH with the lid down for about 10 minutes. When lit, the flame should have a mostly blue color to it. It
may have a tint of yellow and adjustment to the air shutters can be made to obtain a blue flame and proper gas glow (see
flame adjustment) . This appliance should be preheated before cooking with the main burner control settings on HIGH for
five minutes with the hood closed.

Flame Adjustment

a. Become familiar with the safety instructions at the front of this manual. Do not smoke while lighting the
appliance or checking the gas supply connections.
b. Make sure that all gas connections are securely tightened and have been leak-tested with a soapy water
solution - never with a flame!
c.
With the cooking grids and flame tamers removed, light the main burners and run them on the high
d. Inspect burners for proper flame appearance. The ideal flame appearance is one that is mostly blue and not
lifting off of the burner surface. There is an air shutter found at the end of the burner (close to the valve) which
can be either opened or closed to make adjustments to the flame's appearance. To adjust, remove the burner from
the appliance by first removing the cotter pins that holds the burner to the grill bracket. These are located at the bottom
rear of the burner and can be removed with needle nosed plyers. Loosen the phillips head screw holding the air
shutter to the burner. If the flame is yellow, open the air shutter to make the flame more blue. If the flame is lifting
off
of the burner surface, slightly close the air shutter. Re-tighten the phillips head screw and re-install the burner to
recheck the flame appearance. Repeat if necessary.
e. Turn burners to low flame setting and test for proper flame height. Flame should be stable and burning out
of each burner port without danger of going out in the lowest setting. (To adjust the LOW flame setting
simply light the appliance on the LOW setting and adjust the screw located under the knob on the front of
the valve using a flat head screwdriver as seen in the diagram above.)
WARNING: Always be sure the grill control is turned off and the grill is cool before using any type of aerosol cleaner on or around
the grill. The chemical that produces the spraying action could, in the presence of heat, ignite or cause metal parts to corrode.
NOTE: You should clean your appliance after each use to maintain the overall appearance over the life of your appliance. After
the first use, it is normal for your appliance to become discolored in certain areas from the heat produced by the burners. A
with soap, water and a brush until all foreign objects are removed.

Cleaning Your Appliance

Blaze Outdoor Products Instructional Book
Low flame setting screw
Page | 24
setting.