BLAZE BLZ-1PRO-PRT LP Mode D'emploi page 17

by the manufacturer. Do not attempt to repair the Lp tank valve if it is damaged. The cylinder must be turned
over to a proper LP tank servicer and then replaced.
If you are unable to stop a leak turn all control knobs back to the full OFF position, and shut off the gas
•
supply to the appliance.
On LP systems, remove the cylinder from the appliance.
•
Call an authorized gas appliance service technician or an LP gas dealer.
•
Do not use the appliance until the leak is corrected.
•
The below diagram is intended to show what a leaking connection would look like. These two locations are not
•
the only points to check nor the only potential areas for a gas leak to be present.
All gas piping and connections must be tested for leaks after installation or service along with before
•
each use.
This includes all valves, pipe connections, joints, lines and every point from the gas source to the
burners.
All leaks must be corrected immediately.
•
Remember-before exchanging an empty bottle for a new one; make sure all control valves are in
•
the "off" position. This can create a low flow of gas through the grill. This would require the tank to
be disconnected from the regulator, and then reconnected to reset the regulator.
Blaze Outdoor Products Instructional Book
Page | 17