MAXXMEE TS-20143 Mode D'emploi page 25

Mini Heater
4. The device stops the heating process automatically after
the selected operating time has elapsed and switches to
standby mode.
5. To switch off the device, move the On / Off switch (2) to the
0 position.
6. Allow the device to cool down and pull the plug out of the
plug socket.
Using the Device with the Base
Please Note!
■
Always place the device on a dry and heat-resistant surface
with clear space of at least 40 cm above it and on all sides.
If necessary, the device can be set up in a room using the
base (6) and the extension cable that is also supplied (1).
1. Insert the device into the holder (3) of the base. When
you do this, make sure that the bulges on the back of the
device fi t in the recesses of the holder.
2. Press the suction cups (5) of the base fi rmly onto the surface.
3. Alter the angle of the holder if necessary. To do this,
loosen the locking screw (4), tilt the holder with the device
inserted in it forwards or backwards, and fi x the position
using the locking screw (Picture B).
4. Connect the separate extension cable to the device and
use the device as described.
EN
25