Use - MAXXMEE TS-20143 Mode D'emploi

Mini Heater
■
Lay the extension cable so that it is not squashed, bent or
laid over sharp edges and does not come into contact with
hot surfaces (e. g. those of the device).
■
Switch off the device before it is connected to or discon-
nected from the mains power.
■
Pull the mains plug out of the plug socket if an error occurs
during operation or before a thunderstorm. When you pull
the mains plug out of the plug socket, always pull on the
mains plug and never the mains cable!
■
Never pull or carry the device by the extension cable.
■
Protect the device from other heat sources, naked fl ames,
sub-zero temperatures, persistent moisture and impacts.
■
Use only original accessories from the manufacturer in
order to guarantee that there is no interference that may
prevent the device from working and to avoid possible
damage.

USE

Please Note!
■
The device must not be left unattended during operation!
■
The heater without an extension cable should only be used
in wall sockets in a vertical position, and not horizontally
(lying).
■
The device is equipped with overheating protection which
switches off the device if it overheats.
1. Plug the device into a properly installed plug socket that is
easily accessible.
2. To switch on the device, move the On / Off switch (2) to the
I position. On the display (10) 25 (for 25°C) fl ashes and the
heating process starts.
EN
23