Features And Controls - Briggs & Stratton 1227MD Dual Stage Manuel De L'utilisateur

Safety System Test (units with Free
Hand control)
DANGER
Amputation hazard
This snowthrower is equipped with several mechanical
safety systems designed to keep the operator safe while
using the unit. Check the operation of these systems regu-
larly using the safety system tests listed. If the unit fails to
operate as described, DO NOT operate it. See your autho-
rized dealer for service immediately.
Test 1 - Auger/Impeller Control
With the engine running:
• Press down on the auger control lever. (The auger/
impeller should rotate)
• Release the auger control lever. (The auger/impeller
must stop within 5 seconds)
Test 2 - Traction Drive Control
With the engine running and speed control in 1st gear:
• Press down on the traction control lever. (The unit
should move forward)
• Release the traction control lever. (The unit must stop)
Test 3 - Free Hand Control
With the engine running:
• Engage the auger and traction control levers, then
release the auger control lever. (Both controls should
remain engaged)
• Next, release the traction control lever. (Both controls
must release)
8

Features and Controls

Engine Features and Controls
For engine features and controls, please refer to the engine
operator's manual.
Snowthrower Features and Controls
Compare Figure 3 with the table below.
3
B
A
O
N
H
A
F G
K L
K
M
C
D
J E
I
Auger Control Lever - Used
to engage and disengage the
auger and impeller. To engage,
push down. To disengage,
release.