Briggs & Stratton 1227MD Dual Stage Manuel De L'utilisateur page 20

Problem
Unit fails to discharge snow.
20
Look for
Auger drive belt loose or damaged.
Auger control cable not adjusted cor-
rectly.
Broken shear pin or shear bolt.
Discharge chute clogged.
Foreign object lodged in auger.
Remedy
See authorized dealer.
Adjust auger control cable. Refer to
Maintenance section of this manual.
Replace shear pin or bolt. Refer to
Maintenance section of this manual, or
see an authorized dealer.
Stop engine immediately. Always use
the clean-out tool to clear a clogged
discharge chute, not your hands. Clean
discharge chute and inside of auger
housing. Refer to Discharge Chute
Warning in the Operator Safety section.
Stop engine immediately. Always use
the clean-out tool to clear a clogged
chute, not your hands. Remove object
from auger. Refer to WARNINGS in the
Operator Safety section.