Table Des Matières - CIAT EREBA ACCESS 017 T Manuel D'instructions

1 - Physical data and electrical data - model T
2 - Physical data and electrical data - model HT
3 - Dimensions and location of hydraulic connections (mm)
4 - User interface and main switch
4.1. Clearances (mm) for horizontal outlet unit (EREBA ACCESS 017-021)
4.2. Clearances (mm) for vertical outlet unit (EREBA ACCESS 026-040)
5 - General information and hydraulic module
6 - Water connections
7 - Electrical connections and refrigerant charge
8 - Refrigerant charge and electronic control
9 - Start-up, compressor replacement
10 - Pump replacement, unit protection devices
11 - Unit protection devices, operating limits and operating range
12 - General maintenance, maintenance and final recommendations
13 - Troubleshooting
Start-up check list
Equipment sold by: _________________________________________________ Contract No: _________________________________
Installed by: _______________________________________________________ Contract No: _________________________________
Site address ____________________________________________________________________________________________________
Equipment type and serial No:
ELECTRICAL DATA:
Supply voltage
Nominal voltage: _________________________________________ V
Current draw
Control circuit voltage: _____________________________________ V
Main circuit breaker rating ________________________________________________________________________________________
PHYSICAL DATA
Coil:
Entering air temp.: ____________________________°C
Leaving air temp.: ____________________________°C
SAFETY DEVICE SETTING:
High pressure switch: cut-out: __________________kPa
Oil level _______________________________________________________________________________________________________
OPTIONS:
Commissioning engineer _________________________________________________________________________________________
Customer agreement
Name:______________________________________
Note: Complete this start-up list at the time of installation.
CONTENTS
EREBA ACCESS ___________________________________________________________
EREBA ACCESS HT _________________________________________________________
Ph 1: _______________V
Ph 1: _______________A
Start up date _________________________
Ph 2: _______________V
% network voltage ____________________________
Ph 2: _______________A
Control circuit fuse__________________________A
Plate heat exchanger:
Entering water temp.: _____________________ °C
Leaving water temp.: ______________________ °C
Loss of head (water): ______________________ kPa
cut-in: ________________________ kPa
Date: ___________________________________
EN - 1
PAGE
2
3
4
5
5
5
6
8
11
13
14
15
17
19
21
Ph 3: ________________V
Ph 3: _________________A
EREBA ACCESS 17 - 40 T/HT
EN