afriso RG 210 Manuel D'utilisation page 52

5.2.2 Probe
DAMAGE TO THE SYSTEM
• Verify that no foreign matter (such as drilling chips) can get into the tank dur-
ing mounting.
Failure to follow these instructions can result in equipment damage.
Verify that the PTC thermistor cannot be triggered by splashes of the
liquid.
Mounting in a container
1. Suspend the PTC thermistor probe into the container at the cable.
2. Fasten the cable of the PTC thermistor probe at the height of the
desired switching point.
Mounting in a tank
1. Drill a G1 threaded hole at the tank cover.
2. Pull the cable end of the probe through the weight and the screw fitting.
3. Insert the PTC thermistor probe with weight through the hole.
4. Screw in the screw fitting G1 at the container.
5. Fasten the cable of the PTC thermistor probe at the height of the
desired switching point.
Mounting
NOTICE
RG 210
EN
20