Setting The Operating Mode - afriso RG 210 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6
Commissioning
 Verify that the product has been properly mounted and electrically con-
nected.
6.1

Setting the operating mode

 Verify that the upper part of the housing has been removed from the base.
A
1. Loosen the grey cover from the upper part of the housing by means of a
small screwdriver.
2. Pull the printed circuit board out of the upper part of the housing.
3. Se the desired operating mode with the slide switch (B), see chapter
"Function".
4. Refit the printed circuit board.
5. Close the product.
Commissioning
B
A. Mains fuse F1
B. Slide switch for
C
operating modes
D
Operating modes:
E
C. Probe 1
D. Fill
E. Empty
RG 210
EN
25

Publicité

Table des Matières
loading

Table des Matières