Maintenance Instruction - Heyner MultiRelax AERO Fix Guide D'utilisation

English
IMPORTANT:
The diagonal belt should run centrally across the shoul-
der and the lap belt should run as low as possible
across the goin.
Make sure that the diagonal belt runs exactly and that
it is not too close to the body of the child. All the belts
must lie fi rmly against the child's body and must not be
twisted.
A fl at hand should fi t snugly between the belts and the
body of the child. Adjust belt height adjusters, in case
you have them in your car, to the size of the child and to
the size of the seat. Check the run of the belts and the
height of the support for the head from time to time and
adjust them to the growing child.
Please strictly follow the drawings and the installation
instructions.
Should you have any questions, please contact your
dealer, the importer or the manufacturer.

3. Maintenance instruction

Loosen the shoulder belts by pressing the belt adjusters
(GV) and pull the harness belts (G2) towards you.
Do not tear at the shoulder pads.
33
Loosen the belt ends of the harness belts (G2) on the
back side of the seat part (ST) from the belt anchor (R).
Afterwards you can loosen the harness belts (G2) and
the shoulder pad belts (SG) from the adjustment unit
and pull out both belt ends through the shoulder belt
lead-through (G1).
Then, unhook the shoulder pad belts (SG) from the
connecting hook (VH).
In order to remove the crotch belt, push the belt, to-
gether with the metal plate, out of the seat part from
bottom to top.
Now the cover can simply be moved off over the crotch
belt and can be
washed at 30°C. The belts and the locks must not be
washed.
ATTENTION:
Do not tumble. Do not dry in dryer.
When you cover again the HEYNER® child car seats, take
care that the harness belts (G2) are properly anchored in
the correct belt anchor (R)
and that the shoulder pad belts (SG) are properly ancho-
English
GB
Press
34