Turning Off The Cooktop; Burner Flame; Light Control - Furrion FGH12D2-BL Manuel D'utilisation

Fig. 16
2. Push and turn the appropriate burner control knob
counterclockwise to the
Fig. 17
3. Rotate the control knob clockwise or counterclockwise
to adjust the flame to desired level. See the "Burner
Flame" section for proper flame. (Fig.18)
Fig. 18
If the Flame Goes Out
WARNING
Risk of Fire!
If the flame goes out accidentally, gas will escape. Never
leave the gas burner unattended during operation. Ensure
that there are no drafts that can affect the burner flame.
Immediately turn the control knob to the OFF position. Wait
at least 5 minutes and light the burner again.

Turning Off the Cooktop

WARNING
Always turn off the gas tank valve when refueling or
traveling.
To turn the cooktop off, push and turn the control knob
clockwise to the OFF position.
position.(Fig.17)

Burner Flame

A good flame should be blue with a yellow tip.
Some yellow tips on flames up to 1" (25.4mm) in length are
acceptable as long as no carbon or soot deposits appear.
If flames are excessively yellow and irregular, the oil residue
may not be completely burned off, or the venturi may be
clogged or may not be properly positioned over the orifices.
Flames should appear similar to the good flame shown in
diagram below.
Good
Blue
Yellow

Light Control

Move the switch to the appropriate position to turn on/off the
control knob backlight.
Position
All control knob lights are on:
–
The knob will only display Blue color
I when switch activated.
–
BLUE light is a decoration light while all
control knobs are in the OFF position.
All control knob lights are off:
–
O
The knob will display the red color when
the knob are not in the OFF position.
NOTE: RED light is treated as an operation indicator light.
When the burner control is turned on, the KNOB LEDS will
turn RED.(Fig.19)
Fig. 19
- 8 -
Bad
Yellow
Holes in Burner
Description
CCD-0006069 Rev: 07-09-22
Blue