Table des Matières
Publicité
Page 4 of 8
shown in the assembly diagram.
•
Offer the exhaust hanger into position on the bike affix the two bolts into the corresponding
threaded holes on the frame left by the foot peg hanger.
•
Ensure the exhaust hanger lines up correctly with the exhaust and tighten the bolts to the
recommended torque using a 6mm Hex key.
•
Place one M8 Washer (ITEM 2) over the M8 x 25mm button head bolt (ITEM 4).
•
Place the bolt through the exhaust hanger bracket hole and exhaust mount hole.
•
Place the remaining M8 washer (ITEM 2) over the thread protruding from the exhaust followed
by the Nyloc nut (ITEM 5) as shown in the assembly diagram.
•
Tighten the nut using a 13mm spanner and 5mm Hex key, ensuring the exhaust it securely held
in place.
Please note that it is your responsibility to ensure that no part of the exhaust hanger or
exhaust assembly fouls or comes into contact with other parts of the machine. Do not ride
the motorcycle until this aspect has been verified and you have compressed the rear
suspension (if appropriate to the design of the motorcycle) to test this thoroughly.
•
After riding the bike, check the tightness of the bolts regularly (e.g. when cleaning the bike).
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design
changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order.
The Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other
than those in R&G's order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality
and suitable for its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable
skill and care and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for
ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any defective Products
R&G shall at its option either supply a replacement or refund the purchase money but shall not be liable if the Products have
been modified or used or maintained otherwise than in accordance with R&G's or manufacturer's instructions and good
engineering practice or if the defect arises from accident or neglect. Other than identified above and subject to R&G not limiting
its liability for causing death and personal injury, it shall not be liable for indirect or consequential loss and otherwise its liability
shall be limited to the amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do not affect
the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if
they were purchased direct from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods
must be in re-sellable condition, in the opinion of R&G Racing. All returns are subject to a 25% restocking and handling fee (25%
of the gross value exc. P&P – at the prevailing price at time of purchase). The customer must pay any and all carriage charges.
No returns of discontinued products, unless within 14 days of purchase. This policy does not affect your statutory rights and does
not refer to faulty goods.
Unit
Tel: +44 (0)
420 89007 Fax: +44 (0)
1
ISSUE 1
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
1
420 87301
1
10/09/2020
(DM)
CONSUMER NOTICE
R&G
www.rg-racing.com
EH0101
Email:
info@rg-racing.com
Publicité
Table des Matières
