Table des Matières
Publicité
Page 3 of 8
•
Remove the original RHS pillion footrest from the bike. To do this, first remove the OEM nut
from the back of the original exhaust using a 12mm spanner and 8mm Hex key to hold the bolt.
•
Remove the OEM bolt to disconnect the exhaust can from the hanger. Ensure the exhaust does
not drop or change position during throughout this fitting process.
•
Using a 12mm socket, remove the 2 upper bolts connecting the pillion foot peg hanger to the
bike and remove carefully.
•
Place one M8 washer (ITEM 2) over each of the shorter 20mm bolts (ITEM 3).
•
Thread these bolts into the upper holes of the R&G Exhaust hanger (HB0101 – ITEM 1) as
Unit
Tel: +44 (0)
420 89007 Fax: +44 (0)
1
ASSEMBLY DIAGRAM
FITTING INSTRUCTIONS
, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
1
420 87301
1
R&G
www.rg-racing.com
EH0101
Email:
info@rg-racing.com
Publicité
Table des Matières
