System Diseqc 1.0/1.1; Antenna E Satellite Configuration; Channel Search For Satellite - Tele System Palco LED08 Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TELE System
IF Channel
Freq.
Press Exit to save settings and return to the previous screen and continue with the
channel search as shown in paragraph 8.1.2.
CAUTION
If two receivers are connected in cascade to the antenna signal via the LNB OUT pass-
through connector, they cannot operate simultaneously. When a receiver is switched on,
the other must be placed in stand-by (not supplied with the tuner) and vice versa
To connect multiple receivers to a SCR system, do not use the connection through
antenna receiver, but use a suitable divider external signal.

9.3 System DiSEqC 1.0/1.1

The DiSEqC 1.0 / 1.1 protocol has been developed for receiving multiple satellites via
antenna systems with multiple converters, also known as multi-feed, and up to four
different orbital positions for the DiSEqC 1.0 and up to sixteen for DiSEqC 1.1.

9.3.1 Antenna e satellite configuration

From the Antenna Set Up perform the following options:
Satellite: chose the desired satellite. Highlight the satellite and press OK to confirm and
press ►.
LNB type: inferior/superior frequency of the local oscillator of the converter
LNB supply: LNB supply for switching between horizontal and vertical polarization
22KHz: signal at 22KHz switching between high and low band
Tone burst: none.
DiSEqC 1.0 o DiSEqC 1.1: select the LNB number based on its aerial system (i.e. Dual-
feed: Hot Bird 13°E on LNB1 and Astra 19.2°E on LNB2)
Motor: none.
NOTE
Repeat the above procedure for each satellite for which you want to perform a channel
search

9.3.2 Channel search for satellite

Se the procedure illustrated in paragraph 8.1.2
14
1
2
1210
1420
3
4
1680
2040

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Tsls09

Table des Matières