Simplified Remote Control; Inserting Batteries; Pc Mode - Tele System Palco LED08 Manuel De L'utilisateur

TELE System
HOLD: Teletext function

4.2 Simplified remote control

POWER: Stand-by On/Off
DTT: switches to DVBT mode
SAT: switches to DVBT mode
EXIT: exit the menu.
NUMERIC BUTTONS: direct selection of channels.
TXT: access Televideo
Mute: temporary interruption of audio.
ARROW KEYS: regulate volume / change sequential channels
OK: Confirm or select a sub-menu. Access the channel list

4.3 Inserting batteries

You have to replace or install the batteries when:
• You buy the product.
• the remote control does not work properly.
Once you open the battery door located on the back of the
remote, insert the 2 batteries (AAA) in the compartment,
making sure to respect the correct polarity as indicated.
Remove the used batteries, which must be disposed of
separately from household waste taking them to any store or
collection point and then repeat the operations for insertion.
To avoid damaging the remote control with the leakage of
corrosive liquid, you should remove the batteries if you plan
not to use the device for a long period of time. Avoid using
different types of batteries or dead and new batteries at the same time.

5 PC Mode

Since it is equipped with a VGA video card, the TV can be used as a PC screen following
this procedure:
With the equipment turned off, connect the two devices via a D-SUB cable (15-pin) for
the Video part and an audio cable for the audio portion. Reset the electrical connection
of the TV and PC. Turn on the TV and from your remote control, press the AV button.
Select the PC mode. Turn your computer on.
8