Display Illustration - Kerbl DigiScale 1000 Guide D'utilisation

6. Display illustration

Display Illustration
CALSP Enter zero point calibration
SCALE Enter weight calibration
SEtUP Enter parameter setting
UAdJ Enter voltage calibration
LoAd1 First calibration point
LoAd2 Second calibration point
LoAd3 Third calibration point
¯¯¯¯¯ Exceed high limit
_____ Exceed low limit
----- Waiting
Err10 Weight less than Min. Capacity
Err11 Accumulated times overflow
Err12 Accumulated weight overflow
Err13 Error in repeat accumulation
no*** Current accumulation times
H**** Front four digit of accumulated weight
L**** Rare four digit of accumulated weight
CLr Ask if you really want to delete accumulated weight
noCLr Give up deletion
88888 Confirm deletion
SHIFt Switch
¯¯¯ Input value is too large
___ Input value is too small
noACC No any accumulated content
-oL- Overload warning
-Lb- Low battery warning
U*.** The voltage of current battery
End End,
OFF Turn off
- Power saving mode
ATTENTION:
For good performance and precise measurement, be careful with daily operation and maintance. Rotate the load rather
than the scale if needed. Do not use the scale under thunder or rain. Check the clips, pins and screws regularly. When
battery is out of power and battery indicator turns red, check the battery or replace it with a full one. Hang the scale on
special shelf in dry and well-ventilated room. Do not place scale on the ground directly.
Remarks
LoAd1<LoAd2<LoAd3
Tare weight can't exceed full capacity
Tare weight can't be negative
Can't accumulate the value
Can't accumulate after 30times
Can't accumulate after 99999)
Can't accumulate one weight repeatedly
Total weight=front four digit + rare four digit
Total weight=front four digit + rare four digit
In case error deletion
When you input tare or weight value
When you input tare or weight value
when you check accumulation
Tare + Net weight exceed full capacity + 9e
Turn off automatically one minute later
when parameter setting or calibration ready
24