SORHEA SOLARIS Notice D'installation page 45

SORHEA
Stage:
1
2
Push the button "Select" more than
2s until the buzzer signal makes 3
3
(the alignment starts with cell 1)
Turn the cell on both axes until you
have the maximum sound on the
4
buzzer and the fastest flashing on
the indicator light.
5
6
For the next cell, push briefly on the
7
The flashing of the indicator light
and the beeps of the buzzer indicate
the cell number to be aligned.
8
9
10
Push the button "Select" for more
than 2s until the buzzer makes 3
11
short beeps to leave the alignment
Note: the potentiometer of the beam power is only taken into account in the alignment mode.
It has no effect in the detection mode.
RX column
/
/
short beeps.
/
In case the continuous sound cannot be obtained, go to stage 7.
/
button "Select".
/
/
Do stage 4 again for each cell.
/
mode.
Adjust the power potentiometer of
the beam to the maximum.
Push the button "Select" for more
than 2s until the buzzer signal
(the alignment starts with cell 1)
max.
sound
Turn the cell on both axes until you
have the maximum sound on the
buzzer and the fastest flashing on
Lower the power of the beam with
the potentiometer until you have a
discontinuous sound of the buzzer
and the flashing of the indicator light.
Do stage 4 again
For the next cell, push briefly on the
The flashing of the indicator light
and the beeps of the buzzer indicate
the cell number to be aligned.
Adjust to the maximum the
potentiometer of the beam power.
Push the button "Select" for more
than 2s until the buzzer makes 3
short beeps to leave the alignment
- 44 -
TX column
makes 3 short beeps.
/
/
the indicator light.
/
button "Select".
mode.
/
SOLARIS
max.
sound