Petsafe Staywell Pet Door Guide De L'utilisateur page 8

Setting the re-latch time
Please note, this feature CANNOT
been fully powered and programmed.
The re-latch time is the length of time that it takes for the bolts to lock after
they have been activated and the key has been removed from range. The
bolts on your dog door have been factory set to re-latch after 2 seconds.
The time can be set between 2 and 20 seconds. The period that you set
the re-latch time will depend on your own dog and your personal preference.
Remove the top cover by pushing fi rmly on the paw prints and
by pushing upwards. Press the manual button once. (Fig. 21).
The LED will fl ash and the bolts will unlock. The dog door is effectively in
manual mode. Press the timer button within 2 seconds (Fig. 22). Each
press of the timer button will increase the re-latch time by one second. Each
time the button is pressed the dog door will emit a high pitched bleep.
Once the time out reaches 20 seconds the timer reverts to 2 seconds, emits
a low tone bleep and the cycle starts again.
Once the desired amount of seconds has been selected, wait 2 seconds
for the dog door to return to manual mode (there is nothing to indicate this
as the bolts will remain open). Press the manual button again to return to
automatic mode (Fig. 21). The LED will fl ash and the bolts will re-lock. The
selected re-latch time is in use.
To extend or reduce the selected re-latch time, simply repeat the steps
above. For example: If a re-latch time of 5 seconds has been selected,
the fi rst high pitched bleep changes the setting to 6 seconds, the second
high pitched bleep to 7 seconds and so on.
7
be used until the dog door has
FIG. 21
FIG. 22