Connect The Cables - Axis 216FD Mode D'emploi

Page 6

Connect the cables

1. Connect the camera to the network using a shielded network cable.
2. Optionally connect external input/output devices, e.g. alarm devices. See page 14 for
information on the terminal connector pins.
3. Optionally connect an active speaker and/or external microphone.
4. Connect power, using one of the methods listed below:
• PoE (Power over Ethernet). If available, this is automatically detected when the
network cable is connected (see above).
• Connect the supplied indoor power supply to the power connector on the camera.
5. Check that the indicator LED:s indicate the correct conditions. See the table on page 15
for further details. Note that some LEDs can be disabled and may be unlit.
AXIS 216FD/216FD-V/216MFD/216MFD-V Installation Guide