Dimensions; Install The Hardware; Connect The Cables - Axis P1347 Guide D'installation

AXIS P13 Network Camera Series Installation Guide

Dimensions

Model
AXIS P1311
AXIS P1343
AXIS P1344
AXIS P1346
AXIS P1347

Install the hardware

!
IMPORTANT! - AXIS P1311/P1343/P1344/P1346/P1347 is designed for indoor and
outdoor use. To use the camera outdoors, it must be installed in an approved outdoor
housing. Please see www.axis.com for more information on outdoor housings.

Connect the cables

1. Connect external input/output devices if required, such as alarm devices. See page 19 for infor-
mation on the terminal connector pins.
2. Connect an active speaker and/or external microphone if required.
3. Connect the camera to the network using a shielded network cable.
4. Connect power, using one of the methods listed below:
• PoE (Power over Ethernet). PoE is automatically detected when the network cable is
connected.
• Connect an external power adapter to the power connector block; see Unit connectors,
on page 18 for wiring information.
5. Check that the indicator LEDs indicate the correct conditions. See the table on page 20 for
more details. Note that the Status LED can be configured to be unlit during normal operation.
H x W x D
46 x 78 x 176 mm (1.8" x 3.1" x 6.9")
46 x 78 x 192 mm (1.8" x 3.1" x 7.6")
46 x 78 x 205 mm (1.8" x 3.1" x 8.1")
46 x 78 x 198 mm (1.8" x 3.1" x 7.8")
46 x 78 x 206 mm (1.8" x 3.1" x 8.1")
Weight
584 g (1.29 lb)
585 g (1.29 lb)
620 g (1.37 lb)
630 g (1.39 lb)
680 g (1.5 lb)
Page 5