RISCO Group ProSYS KP Mode D'emploi page 3

Touchscreen Keypad Touchscreen Keypad Touchscreen Keypad Touchscreen Keypad
Introduction Introduction
Introduction Introduction
RISCO Group's Touchscreen Keypad is a slim and contemporary designed 7" touchscreen keypad
for RISCO Security Systems. The Touchscreen Keypad is compatible with any RISCO hybrid
system and is available with or without a proximity reader. The Touchscreen Keypad enables to
control your security system as well as program its features.
For detailed information on programming the system refer to the system Installer and User manuals.
Installation Installation Installation Installation
For the Touchscreen installation procedure, refer to page 2.
Indicators Indicators Indicators Indicators
Power
Arm (Set)
Stay/
Bypass
(Part Set/
Omit)
Ready
Fire
Tamper
Proximity
System is operating properly from AC power and backup
On
battery is in good condition
Off No power
Slow Flash System is programming
Rapid Flash System trouble (fault)
On System is armed (set) in Full Arm or Stay Arm mode
Off System is disarmed (unset)
Slow Flash System is in Exit Delay
Rapid Flash Alarm condition
System is in Stay Arm (Part Set) or Zone Bypass (omit)
mode
Note:
On
The
keypads.
Off No bypass zones in system
On System is ready to be armed (set)
Off System is not ready to be armed (set)
System is ready to be armed (set) while exit/entry zone
Slow Flash
remains open
On Fire alarm in progress
Off Normal operation
Flashing Fire circuit problem
On Zone/keypad/external module has been tampered
Off All zones are operating normally
Flashing Indicates that the keypad has a proximity reader
icon is equivalent to the
EN
icon on other ProSYS
3