Switching On The Machine; Advice On Electrical Connections - Robot Coupe Blixer 23 Mode D'emploi

4) Clip the lid onto the lid
rest and turn it so that the
bosses are inside the
arm.
The logo should now be
facing you, lined up with
the handle, with the
safety magnet on the
right.
5) To close the lid, fit the
locking catch over the
edge of the bowl and
push the handle down.
DANGER : RISK OF INJURY
The blades are extremely sharp.
For this reason, always make sure you have
removed the blade assembly before doing
any job inside the bowl, such as cleaning or
emptying.
• LID WIPER Assembly -
VERTICAL CUTTER MIXER
Hold the lid wiper in one hand and the handle in the
other. Press the two parts together in the centre of the
lid, then rotate the handle 45° in an anticlockwise
direction.
• BLIXER SCRAPER ARM Assembly
Hold the scraper arm in one hand and the handle in
the other. Press the two parts together in the centre
of the lid, then rotate the handle 45° in an anti-
clockwise direction.
SWITCHING ON
THE MACHINE

• ADVICE ON ELECTRICAL CONNECTIONS

Before plugging in, check that your power supply
corresponds to that indicated on the machine's
serial number plate.
W A R N I N G
This appliance must be plugged into an
earthed socket (risk of electrocution).
These models must be powered from a
208-240 V / 60 Hz
3 Phase power supply.
The machine is supplied with a power cord and a
plug attachment. If wiring to a service disconnect
box, this should be undertaken by a qualified
electrician.
The power cord has four wires, one grounded wire,
plus three phase wires.
Connect the green wire to the ground terminal pin.
These machines do not require a neutral connec-
tion.
7