Lid; Maintenance; Blades; V-Ring Seals - Robot Coupe Blixer 23 Mode D'emploi

Dismantling the blade assembly
- Lift the blade assembly
out of the appliance.
- Remove the bowl.
- Place
remover on the motor
shaft.
- Put the blade assembly back in position.
- Loosen the screw using the hooked blade disas-
sembly tool.
- Dismantle the blade assembly by hand.
- To reassemble the blades, follow these instructions
in the reverse order.
- Make sure you tighten the screw properly after
reassembling the blades, in order to prevent the
latter coming loose.

• LID

For perfect hygiene, remove the washer, cone and
lid rest so that they can each be carefully cleaned.
We advise against putting them in the dishwasher.
Instead, wash them by hand with a little mild liquid
detergent.
If you are not intending to use your appliance for a
while, leave the lid open to avoid wear and tear of
the seals.
Removing the lid seal
1 2
–
- Unhook the lid from the arm.
—
- Put the lid the wrong way round on the bowl.
16
3
the blade
4
6
™ œ
to - Keep inserting the seal progressively on
both sides in order to join both hands.
8
˜
- Start to set the seal at
the hinge side. Hold firm-
Check that your detergent is suitable for
ly the seal with the thumb
cleaning the plastic parts. Certain washing
and the index
agents are too alkaline (e.g. high levels
finger and insert it in the
of caustic soda or ammonia) and totally
lid groove.
incompatible with certain types of plastic, cau-
sing them to deteriorate rapidly.
5

• BLADES

After each task, we strongly recommend you
sharpen the blades briefly with a sharpening stone,
especially after chopping parsley.
Sharpen them thoroughly once a month with
7
the fine-textured sharpening stone supplied with the
appliance.
The quality of the cut depends mainly on the
sharpness of your blades and their degree of wear.
The blades are wearing parts which should be
replaced from time to time, in order to ensure cons-
tant quality of the finished product.

• V-RING SEALS

The sealing sleeve comprises a stainless-steel part
–
, a stainless-steel deflector fitted with a friction

ring
Clip the lid onto the lid
rest and turn it so that the
bosses are inside the arm.
I M P O R T A N T

MAINTENANCE

— ˜
and 2 lip seals .
2
1
3