Control Panel; Powering Up The Machine - Robot Coupe Blixer 23 Mode D'emploi

• CONTROL PANEL

- Dual-speed machines
screen
Buttons for setting timer
"Off" button
"On" button 1 st speed (1800 RPM)
"On" button 2 nd speed (3600 RPM)
green light
Pulse control button 1 st speed (1800 RPM)
orange light
red light

• POWERING UP THE MACHINE

- Start-up
Stage 1
Each time the machine is powered up, the message
« Cx Fyy » will appear on the screen:
- « x » will be a figure between 0 and 7,
corresponding to the control board configuration.
- « yy » will be either "50" or "60", depending on
whether the power supply has a frequency of 50
or 60 Hz.
Example: an R 45 ("2" configuration) operated at 50 Hz will display the
following message:
ª
8
The orange indicator light
will come on.
Stage 2
Open the lid, then close it again, to activate the
safety system. The orange light will remain on.
1
Stage 3
Press the "off" button, then release it. Make sure you
only do this when "0.00" or another duration is
displayed on the screen.
+
Press
Stage 4
The orange light will go
out and the two green
indicator lights will come
on. The machine is now
ready to use.
WARNING:
If you try to start the machine during one of the
above stages by pressing the 1 st or 2 nd speed "ON"
button, or even the "Pulse control" button, nothing
will happen. A troubleshooting message (see table
2 3
on page 18) will appear on the screen.
- Standby
If the machine is left powered up but unused for
between 15 and 120 minutes, without any move-
ment of any of its electrical elements (safety switch,
"Off" button, etc.), the green lights will go out and
the orange light will start to flash.
To quit standby: to reactivate the machine push a
button or operate the lid.
or
or
+ =
or
or