Vertical Cutter Mixers Only; Operating Instructions For The Vacuum Kit R-Vac - Robot Coupe Blixer 23 Mode D'emploi

OPERATING INSTRUCTIONS FOR THE VACUUM KIT R-VAC

VERTICAL CUTTER MIXERS ONLY

1° ASSEMBLING THE VACUUM KIT R-VAC
- Insert filter into body
2 3
- Screw the tube onto the body
1
B
Keep an eye on
the position of the
O-ring seal when
fitting part 1 .
1
Filter can
2
be cleaned.
2
3
Check that the
openings are in
the upper position
in order to position
nut 4 .
5° ADDING LIQUID TO THE MIXTURE
- Attach a tube to valve B.
- Immerse the other end of this tube in the liquid to be added.
- Open valve B slowly ; once the liquid has been added, shut valve B.
®
(the tube should pass through the body
3
2° POSITIONING THE R-VAC
- Sit the R-VAC ® kit on top of the plastic cone
screwed onto the lid rest
lid (opaque white) slots onto the lid rest
9
3° CLIPPING ON THE BELL
- Take the bell in the hollow of your hand and press the pusher
with your thumb.
- Slot it onto the section of tube
the lid.
- Release the pusher .
7
- The pusher should return to its initial position. If it does not, gently
A
press on the bell and it will automatically click into place.
- Check that the bell is securely attached to the tube
4° USING THE VACUUM KIT R-VAC
- Connect up the vacuum pump to valve A, check that the latter is open
(lever in shaft of connector).
- Shut valve B (perpendicular lever).
4
®
).
3
® VACUUM KIT ON THE LID
, which should be
5
, with the lid holder in between. The
6 8
.
6
4
protruding from the underside of
1
.
1
®
Preheat the vacuum pump (approx. 15 minutes) to check that both
it and the vacuum kit are working properly. Similarly, leave the
pump running for 15 minutes after completing the task in order to
evacuate the condensation.
in
7
9
7
N O T E
5
8
6
4
13