Pan Detection; Residual Heat Indication; Booster Function - Kuppersbusch K Serie Mode D'emploi

• Start up / switch off a heating zone:
Action
Zone selection
Select the power level
To stop
If no action is made within 20 second the electronics returns in waiting position.

Pan detection

The pan detection ensures perfect safety. The induction doesn't work:
• If there is no pan on the heating zone or if this pan is not suitable to the induction. In this
case it is impossible to increase the power and the display shows [ U ]. This symbol
disappears when a suitable pan is put on the heating zone.
• If the pan is removed from the heating zone. The operation is stopped. The display shows
[ U ]. The symbol [ U ] disappears when the pan is put back on the heating zone. The
cooking continues with the power level set before.
After use, make sure that the heating elements have been switched off: don't leave the pan
detection [ U ] active.

Residual heat indication

After the switching off of a heating zone or the complete stop of the hob, the heating zones are
still hot. This is indicated by displaying [ H ] symbol.
The symbol [ H ] disappears when the heating zones may be touched safely.
As long as the residual heat indicators are on, don't touch the heating zones and don't put any
heat sensitive object on them. There are risks of burn and fire.

Booster function

The Power function [ P ] grants a boost of power to the selected heating zone.
If this function is activated the heating zones work during 5 minutes with an ultra high power.
Power is foreseen for example to heat up rapidly big quantities of water, like nuddles
• Start up / Stop the booster function:
Action
Zone selection
Start up the Power
Stop the Power
• Power management:
When it comes to the power, the cooking zones are running by pairs and cannot exceed an
overall maximum of power. If the selected heating levels for both zones exceed the maximum
available amount of power, the powermanagement function is automatically reducing the power
from one of these zones. The display of this zone is first blinling ; the level is then automatically
reduced to the highest suitable position.
Heating zone selected
[ P ] is displayed
Control panel
Press on the "SLIDER"
across from the desired zone
Slide on the "SLIDER"
Slide to [ 0 ] on "SLIDER"
Control panel
Press on the "SLIDER"
across from the desired zone
Slide on the "SLIDER"
Slide on the "SLIDER"
The other heating zone: (example: power level 9)
[ 9 ] goes to [ 8 ] and blinks
29
Display
[ 0 ]
[ 1 ] to [ P ]
[ 0 ] or [ H ]
Display
[ 0 ]
[ 0 ] to [ P ]
[ P ] to [ 0 ]