Cembre B1300-C-KV Notice D'utilisation Et D'entretien page 8

NOTE:
To display the momentary force or pressure during
the work cycle, select the appropriate display from the
menu (Ref. to § 4). When the operating button is released
before the motor stops automatically, the display will show
the peak force (Fp) or the peak pressure (Pp) reached at
that instant.
To complete the work, press the operating button again until the motor stops automatically; the dis-
play will show the maximum force or pressure reached followed by 'OK' to confirm correct operation.
The display 'ERROR' , combined with a beep and the LEDs flashing,
= 125.2 kN
F
m
indicates an incorrect crimping procedure caused by the work cycle
= 102.3 kN
p
being interrupted before the control parameters (force/pressure) of the tool
are reached. This error appears when the pressure release button has been operated and the
= 692 bar P
m
tool has already reached a pressure > 100 bar. In this case, repeat the compression by pressing
= 565 bar
p
and holding the operat ing button until the motor stops automatically.
max.
2.4) Release of dies
By operating the pressure release button (2),
the ram will retract and open the dies.
BATTERY
To take the dies off their guide, slide them while pushing the
release pins (12 and 14) (Ref. to Fig. 2).
2.5) LED Worklights
Whilst the tool is in operation, the compression area is illumi-
nated by two high luminosity LED Worklights that switch off
automatically at the end of the cycle.
LED
ON
The LED Worklights can be disabled by following the procedure described in § 4.2.
LED
OFF
2.6) Head rotation
For ease of operation, the tool head can rotate through 180°, allowing the operator to work in the
most comfortable position.
Do not attempt to rotate the head when the hydraulic circuit is pressurised.
2.7) Capacitive touch button for menu selection
This button is located under the display and allows selection of
various screens (Ref. to § 4); it only works when the display is on.
Wearing gloves or using other objects may inhibit the operation of the
button, therefore use a bare finger to apply only a light touch.
F = 125.2 kN
m
Fp = 94.5 kN
F = 14.07 ton
m
= 125.2 kN
m
Fp = 10.61 ton
OK
= 692 bar
m
P = 692 bar
m
OK
Pp = 522.3 bar
min.

P = 10037 psi
m
Pp = 7575 psi

BATTERY
BATTERY
1000
-12000
B1300
NR 14AF035
3 SEC.
BATTERY 
BATTERY


RESET
SW:S1J41AH
LED
OFF
3 SEC.
LED
ON
F = 125.2 kN
m
F = 102.3 kN
p
P = 692 bar
m
P = 565 bar
p
max.
BATTERY

13001
LED
ON
LED
OFF
F = 125.2 kN
m
OK
P = 692 bar
m
OK
min.



BATTERY
ERROR


001


002
2

F = 125.2 kN

m
Fp = 94.5 kN
003


F = 14.07 ton
m
004
Fp = 10.61 ton

P = 692 bar
m
Pp = 522.3 bar
P = 10037 psi
m
Pp = 7575 psi
BATTERY
1000
-12000
B1300
NR 14AF035
3 SEC.
8