Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.4) ERRORS:
these appear during operation, combined with a beep and flashing
LED Worklights, to notify the operator of procedural or operational errors.
Message
Error description
The pressure release button (2)
was pressed before the control
ERROR
ERROR
parameters were reached (Force/
Pressure).
ERROR
ERROR
Abnormal power consumption
ERROR
of the motor for more than 3
001
001
seconds.
The tool stops.
001
001
002
002
Output voltage of the pressure
001
002
transmitter is out of the pre-set
002
range.
003
003
002
Failure to reach the set pressure
003
003
within 30 seconds of continuous
004
004
operation of the machine.
003
004
Overcharging of the battery with
004
protection tripping.
004
The tool stops.
Errors are displayed for about 30 seconds before being reset, but will display repeatedly in
the event of permanent anomalies.
5. CONNECTION TO COMPUTER
The memory card integrated in the tool records operating data from 200.000 cycles for transfer via
the USB cable supplied.
To view and manage this data, go to www.cembre.com and register in the dedicated area, then
download the free Cembre software CEM_SWBT01.
Keeping the Firmware of the tool updated, via free of charge download from here, will optimise
the tool's performance.
– Following information applies in member states of the European Union:
USER INFORMATION in accordance with "Directives 2002/95/EC and 2002/96/EC.
The 'Not in the bin' symbol above when shown on equipment or packaging means that the equipment
must, at the end of its life, be disposed of separately from other waste.
The separate waste collection of such equipment is organised and managed by the manufacturer.
Users wishing to dispose of such equipment must contact the manufacturer and follow the prescribed
guidelines for its separate collection. Appropriate waste separation, collection, environmentally compat-
ible treatment and disposal is intended to reduce harmful environmental effects and promote the reuse
and recycling of materials contained in the equipment. Unlawful disposal of such equipment will be sub-
ject to the application of administrative sanctions provided by current legislation.
Solution
Repeat the work cycle and wait for the
motor to stop automatically.
Wait for the display to turn off (60 sec.)
or remove and re-insert the battery,
then re-start the tool.
If the error occurs frequently, contact
Cembre.
Repeat the work cycle; if the error
occurs frequently, contact Cembre.
Repeat the work cycle; if the error
occurs frequently, contact Cembre.
Wait for the display to turn off (60 sec.)
or remove and re-insert the battery,
then re-start the tool.
If the error occurs frequently, contact
Cembre.
12
Publicité
Table des Matières
