Surface Installation - Dimplex PRISM 50 Manuel D'utilisation

Fireplace Installation
the fireplace is packaged with a plug
installed for plug-in convenience.
Hard wiring the fireplace is also
an option by removing the plug
from the factory fitted cord and
completing the wiring according to
national and Local elecrical Codes.
WARNINg: Do not attempt to
wire your own new outlets or
circuits. to reduce the risk of fire,
electric shock or injury to persons,
always use a licensed electrician.

Surface Installation

CAUTION: Two people may
be required for various steps of
this procedure.
1. Choose
mounting the unit.
2. Choose
supplying power to the unit:
• Plug in to an existing outlet or
install an outlet nearby.
• Hard wire the fireplace.
!
NOTE: Hard wiring can be
done by removing the plug
from the factory fitted cord
and completing the wiring
according to national and
Local elecrical Codes.
a location
your method
Figure 2
Glass Bracket
WARNINg: Do not attempt to
wire your own new outlets or circuits.
to reduce the risk of fire, electric
shock or injury to persons, always
use a licensed electrician.
ensure that the 3-Position Switch is
for
set to the Off position ("O") and that
the circuit on which the fireplace is to
of
be installed has the power cut off at
the service panel until installation is
complete.
3. remove the partially reflective
glass from the fireplace:
• Lay fireplace on its back.
• Remove
screws from each of the two
(2) glass brackets (Figure 2).
• remove glass brackets.
• With
Bracket Screws
Partially
reflective Glass
two (2)
one hand
Phillips
keeping
9