Service Air Filter - Briggs & Stratton Broadmoor Manuel D'utilisation

12
10. Lightly lubricate the oil filter gasket (A) with clean oil.
11. Install the oil filter by hand until the gasket touches the oil
filter adapter (C) then tighten the oil filter 1/2 to 3/4 turns.
12. Add oil. See the Check and Add Engine Oil section.

Service Air Filter

Refer to the Engine Manual.
Air Filter Assembly (Cartridge with pre-cleaner)
WARNING
DO NOT start or run the engine with the air cleaner
assembly or air filter removed as it is a fire hazard.
NOTICE
Do not use pressurized air or solvents to clean the filter.
Pressurized air can damage the filter, and solvents will
dissolve the filter.
1. Loosen the fasteners (A, Figure 13) and remove the
cover (B).
13
2. Remove the air cleaner assembly (C) and disassemble.
3. Remove debris that might get into the carburetor throat
(D).
4. Remove the pre-cleaner from the air filter.
5. To loosen debris, gently tap the air filter on a hard
surface. If the air filter is dirty, replace it with a new air
filter.
6. Wash the pre-cleaner in liquid detergent and water. Then
let it thoroughly air dry. Do not lubricate the pre-cleaner.
7. Assemble the dry pre-cleaner to the air filter.
8. Install the air filter assembly.
9. Install the cover and secure with fasteners.
Air Filter Assembly (Cyclonic with pre-cleaner)
WARNING
DO NOT start or operate the engine with the air cleaner
assembly or air filter removed as it is a fire hazard.
NOTICE
Do not use pressurized air or solvents to clean the filter.
Pressurized air can damage the filter and solvents will
dissolve the filter.
1. Loosen the fasteners (A, Figure 14) and remove the
cover (B).
17