Briggs & Stratton Broadmoor Manuel D'utilisation page 16

Change the Engine Oil
1. Run the engine until warm.
2. Put the tractor on a level surface (Figure, 10).
10
3. Stop the engine and remove starter insert (A, Figure 10).
4. Clean the oil fill and filter areas of any debris.
5. Remove dipstick (B) and lay on clean cloth.
6. Disconnect the oil drain hose (A, Figure 11).
16
11
7. Carefully remove the cap (B) and lower hose into an
approved container (C).
8. After the oil has drained, install the cap tightly, then attach
the hose to the side of the engine.
9. Remove the oil filter (B, Figure 12) and discard.