PULOX PO-100 Mode D'emploi page 20

current may cause burn.

Do not take the information displayed on the device as the sole basis for
clinical diagnosis. The device is only used for auxiliary means in
diagnosis. And it must be used in conjunction with doctor's advice,
clinical manifestations and symptoms.

Maintenance of the device: Users are not permitted to maintain or refit
the device by themselves.

Uncomfortable or painful feeling may appear if using the device
ceaselessly, especially for the microcirculation disturbance users. It is
recommended that the sensor should not be applied to the same finger
for over 2 hours.

For some special users who need a more careful inspection on the test
site, please don't place the device on the edema or tender tissue.

Please do not stare at the red and infrared light emitter (the infrared
light is invisible) after turning on the device, including the maintenance
staff, as it may be harmful to the eyes.

The device contains silicone, PVC, TPU, TPE and ABS materials, whose
biocompatibility has been tested in accordance with the requirements in
ISO 10993-1, and it has passed the recommended biocompatibility test.
The person who is allergic to silicone, PVC, TPU, TPE or ABS can not use
this device.

Do NOT strand the lanyard to avoid device drop and damage. The
lanyard is made of insensitive material. Please do not use it if any person
is allergic to lanyard. Do not wrap the lanyard around neck to avoid an
accident.

The disposal of scrap device, its accessories and packaging should follow
the local laws and regulations, to avoid polluting to the local
environment. And the packaging materials must be placed in a place out
of childrens' reach.

The device can not be used with the equipment not specified in the
manual. Only the accessories appointed or recommended by the
manufacturer can be used, otherwise it may cause injury to the tester
and operator or damage to the device.

Check the device before use to make sure that there is no visible damage
that may affect user's safety and device performance. When there is
obvious damage, please replace the damaged parts before use.

Functional testers can not be used to assess the accuracy of the Pulse
EN