Subaru H101SSJ000 Instructions D'installation page 7

SYSTEM REGISTRATION
10
ENSURE THE SOFTWARE VERSION HAS BEEN UPDATED TO THE LATEST REVISION
BEFORE ATTEMPTING SYSTEM REGISTRATION.
DST-i SETUP
Plug the DST-i
diagnostic plug
into the vehicle's
diagnostic connector
REGISTRATION
1. PRESS IMMOBILIZER ETC. REGISTRATION
AND PRESS SELECT
PRESS
3. PRESS H TYPE FOR PUSH START MODELS
PRESS CONFIRMED AND WAIT FOR LAPTOP
TO ESTABLISH CONNECTION
PART NUMBER ISSUE
H101SSJ000
PRESS
PRESS
PRESS
DATE
- 21 Dec 2021
Plug the DST-i
USB plug into a
Network-Enabled
laptop
2. PRESS FORESTER AND PRESS SELECT
With an Access key
inside the vehicle
turn ON the ignition
4. PRESS REMOTE ENGINE START CM
REGISTRATION AND PRESS CONFIRMED
SUBARU OF AMERICA
Select/Open the SSM4
software on the
Network-Enabled
laptop
PRESS
PRESS
PRESS
PRESS
PRESS
PRESS
7 OF 10