Subaru H101SSJ000 Instructions D'installation page 4

5
REMOTE ENGINE START ECU MOUNTING
1. Locate the glove box inner cover and remote engine start
ECU. Using alcohol, clean the back side of the glove
box inner cover and ECU, as shown. (FIGURE G)
2. Using the supplied double sided tape, remove the two
(2) small release liners and attach the tape to the glove
box inner cover. Ensure the tape is positioned against
the vertical character line and fl at against the multi-level
inner cover. Press fi rmly in place for at least 30 seconds.
(FIGURE H)
NOTE: Ensure the double sided tape is positioned
away from any obstructions on the glove box inner
cover.
3. Remove the one (1) large release liner from the double
sided tape and attach the remote engine start ECU.
Ensure the corner of the ECU, closest to the small gray
connector, is fl ush with the upper left corner of the tape,
as shown. Press fi rmly in place for at least 30 seconds.
(FIGURE I)
NOTE: Ensure the ECU connectors will be facing
toward the passenger's side of the vehicle when the
inner cover is replaced.
ISSUE
PART NUMBER
H101SSJ000
DATE
-
21 Dec 2021
Clean with
Alcohol
FIGURE G
Vertical
Character
Line
FIGURE H
Mount Corner
of ECU Flush
with Corner of
Foam Tape
FIGURE I
SUBARU OF AMERICA
Obstruction
Obstruction
4 OF 10