Subaru H101SSJ000 Instructions D'installation page 5

6
PRE-ARRANGED JUMPER HARNESS CONNECTIONS
1. Locate and release the vehicle's 6-pin and 2-pin pre-fi t
connectors secured to the vehicle's wire harness with
breakaway tape near the upper right, passenger's side
glove box area. (FIGURE J)
2. When the vehicle's 6-pin and 2-pin pre-fi t connectors
are free from the breakaway tape, unplug and discard
the 2-pin mating connector/wire jumper. (This is used
for the power window interrupt circuit).
3. Plug the remote engine start jumper harness 6-pin
and 2-pin connectors into the corresponding pre-fi t
connectors. (FIGURE K)
4. Using one (1) of the supplied 39cm tie wraps, secure
the pre-arranged jumper harness connectors to the
vehicle's wire harness. Using two (2) of the supplied
39cm tie wraps, secure the pre-arranged jumper
harness to the vehicle's wire harness, as shown. Trim
off the excess tie wraps. (FIGURE L)
5. Plug the pre-arranged jumper harness 12-pin connector
into the 12-pin white port on the remote engine start
ECU, previously mounted to the back side of the glove
box inner cover (Step 5).
PART NUMBER ISSUE
H101SSJ000
DATE
- 21 Dec 2021
FIGURE J
FIGURE K
FIGURE L
SUBARU OF AMERICA
5 OF 10