hajdu HB200 Manuel De Mise En Service, D'opération Et D'entretien page 83

_________________________________ ___EN__________________________________36
Filter installation to the air inlet of the appliance. If the appliance is connected to air
duct, a filter must be mounted to the air inlet of the air duct.
In order to drain condensate water continuously, please install the appliance on a
horizontal floor. If this is not possible, please ensure that the drain vent is at the
lowest possible place. It is recommended to place the appliance in a way that the
inclination angle between the appliance and a vertical line is not more than 2°.
First start up
9.2.
Before first start up of the appliance, please, check the following
elements:
Filter
Figure 7.2.-8.
Drain
Figure 7.2.-9.
The filter must be mounted by the
user of the appliance, the mesh size
is about 1.2mm.
Figure 7.2.-10.
Drain