Location Requirements; Installation Clearances - Maytag YMED7500YW Guide D'utilisation Et D'entretien

LOCATION REQUIREMENTS

Check code requirements. Some codes limit, or do not permit,
installing dryer in garages, closets, mobile homes, or sleeping
quarters. Contact your local building inspector.
You will need:
n A location allowing for proper exhaust installation.
See "Venting Requirements."
n A separate 30 amp circuit.
n A grounded electrical outlet located within 2 ft. (610 mm) of
either side of dryer. See "Electrical Requirements."
n Floor must support dryer weight of 200 lbs. (90.7 kg).
Also consider weight of companion appliance.
n Level floor with maximum slope of 1" (25 mm) under entire
dryer. If slope is greater than 1" (25 mm), install Extended
Dryer Feet Kit, Part Number 279810. If not level, clothes
may not tumble properly and automatic sensor cycles may
not operate correctly.
n For garage installation, place dryer at least 18" (460 mm)
above floor. If using a pedestal, you will need 18" (460 mm)
to bottom of dryer.
n The dryer must not be installed or stored in an area where
it will be exposed to water and/or weather.
IMPORTANT: Do not operate, install, or store dryer where
it will be exposed to water, weather, or at temperatures below
45° F (7° C). Lower temperatures may cause dryer not to
shut off at end of sensor cycles, resulting in longer drying times.

Installation Clearances

For each arrangement, consider allowing more space for ease
of installation and servicing, spacing for companion appliances,
and clearances for walls, doors, and floor moldings. Space
must be large enough to allow door to fully open. Add spacing
on all sides of dryer to reduce noise transfer. If a closet door
or louvered door is installed, top and bottom air openings
in door are required.
Check code requirements. Some codes limit, or do not permit,
installation of the dryer in garages, closets, mobile homes, or
sleeping quarters. Contact your local building inspector.
10
DRYER DIMENSIONS
Front view:
33 / "
1
4
(845 mm)
Side view:
Back view:
3
(83 mm)
NOTE: Most installations
require a minimum of 3"
(76 mm) clearance behind
dryer for exhaust vent
with elbow. See "Venting
Requirements."
(686 mm)
/
23 "
3
8
(594 mm)
39"
(991 mm)
/
23 "
1
4
(603 mm)
/
"
1
4
Power supply
cord/cable
27"
Vent
(299 mm)
/
11 "
3
4