Connections; Dip Switch Setting - Panasonic WV-CU161 Mode D'emploi

CONNECTIONS

Check the DIP switch settings before connecting this controller. They need to be changed only if you want to change the sys-
tem settings.
The following setting procedure should be made by qualified service personnel or system installers.

DIP Switch Setting

Caution: Unplug the AC cord before changing any DIP switch setting.
Removing the Bottom Cover for SW1
1. Take off the bottom cover by removing the two screws.
Removing the Bottom Panel for
SW100
1. Take off the side panels by removing the four screws.
2. Take off the bottom panel by removing the 8 screws.
SW1
SW1 lets you choose 0/5V or open collector (O.C.) for
the alarm recover output signal.
0/5V: +5 V DC approx. 500 m sec.
Open Collector (O.C.): 16 V DC 100 mA max.
The initial factory setting is 0/5V.
O.C
SW4
Confirm that SW4 on the board is set as shown below.
This switch is used only for factory tests. Do not change
this switch setting.
Bit
ON
OFF
10
All manuals and user guides at all-guides.com
SW1
0/5V
1 2 3 4
SW4
SW1
Panasonic
q
Remove four screws.
SW100
SW100 lets you choose the mode for displaying charac-
ters on the monitor.
NOR
NOR: White with Black border
REV: Black with White border
The initial factory setting is NOR.
Remove two screws.
Bottom Cover
w
Remove four screws.
SW100
SW100
REV