Porter Cable Clampsaw PCC475 Mode D'emploi page 9

TO REMOVE BATTERY PACK: Depress the battery release
button as shown in figure D and pull battery pack out of
tool.
OPERATING INSTRUCTIONS
WARNING: Always wear proper eye and respiratory protection while operating this
tool.
• Use clamps or another practical way to secure and support the workpiece to a
stable platform. Holding the work by hand or against your body leaves it unstable
and may lead to loss of control.
• Place shoe firmly against work to be cut.
• Switch on saw motor and allow it to obtain maximum speed before applying pressure.
The tool can be converted into three
THREE POSITION SAW (FIGURES E & F)
different positions. To change positions:
• Slide the pivot release slider (3) to the
right as shown in figure E and rotate the
handle portion of the tool into any of the
three positions shown in figure F.
NOTE: Verify that the saw is in a locked
position before using.
THREE POSITION SAW WARNINGS:
• To avoid being pinched, keep hands away
from the hinge when changing positions.
• To avoid tool being turned on accidentally,
make sure the lock-off button is engaged.
All manuals and user guides at all-guides.com
9
D
E
3
F