Porter Cable Clampsaw PCC475 Mode D'emploi page 10

The tool is equipped with a switch lock-off
TRIGGER SWITCH (FIGURE G)
feature to prevent unintentional operation.
• To switch the tool on, press the lock off
button (2), then squeeze the on/off switch (1).
• Releasing the trigger turns the motor OFF.
NOTE: This tool has no provision to lock
the switch in the ON position, and should
never be locked in the ON position by any
other means.
CAUTION: Make sure the lock-off button is engaged to prevent switch actuation
ADJUSTING SHOE (FIGURE H & I)
before making any adjustments or removing or
installing attachments or accessories.
• Press in on the shoe adjustment button (6) figure H.
• Pull the adjustable shoe (7) out to the desired
distance. The saw can be used in this position
when cutting thinner material. Release shoe
adjustment button.
• When cutting pipe or similar workpiece, place the
shoe over the object being cut as shown in
figure I. Adjust the shoe so that it is snug but still
allows for slight movement of the workpiece.
Release shoe adjustment button to lock shoe in
place.
CAUTION: Cut hazard. To prevent loss of control,
never use tool without shoe.
damage. Ensure the shoe is
CAUTION: Risk of personal injury and property
locked into position before using tool.
BLADE INSTALLATION AND REMOVAL
The blade should extend past the shoe and the
|(FIGURE J)
thickness of the workpiece during the cut. Select the blade best suitable for the
material to be cut and use the shortest blade suitable for the thickness of the material
Do not use jigsaw blades with this tool.
WARNING: Cut hazard. Blade breakage may
occur if the blade does not extend past the shoe
and the workpiece during the cut. Increased risk of
personal injury, as well as damage to the shoe and
workpiece may result.
CAUTION: Make sure the lock-off button is
engaged to prevent switch actuation before
making any adjustments or removing or installing
attachments or accessories.
All manuals and user guides at all-guides.com
G
10
2
1
H
I
J
8
6
7