Storage Recommendations; Charging Procedure - Porter Cable Clampsaw PCC475 Mode D'emploi

• Do not charge or use battery in explosive atmospheres, such as in the presence of
flammable liquids, gases or dust. Inserting or removing the battery from the charger
• If battery contents come into contact with the skin, immediately wash area with
may ignite the dust or fumes.
mild soap and water. If battery liquid gets into the eye, rinse water over the open eye for
15 minutes or until irritation ceases. If medical attention is needed, the battery electrolyte
for Li-ion batteries is composed of a mixture of liquid organic carbonates and lithium
• Contents of opened battery cells may cause respiratory irritation. Provide fresh air.
salts. For NI-CD batteries it is a 25-35% solution of potassium hydroxide.
If symptoms persist, seek medical attention.
• Charge the battery packs only in PORTER-CABLE chargers.
WARNING:
Burn hazard. Battery liquid may be flammable if exposed to spark or flame.
• DO NOT splash or immerse in water or other liquids. This may cause premature cell
• Do not store or use the tool and battery pack in locations where the temperature
failure.
may reach or exceed 105°F (40˚C) (such as outside sheds or metal buildings in
summer).
WARNING:
Never attempt to open the battery pack for any reason. If battery pack
case is cracked or damaged, do not insert into charger. Do not crush, drop or damage
battery pack. Do not use a battery pack or charger that has received a sharp blow, been
dropped, run over or damaged in any way (i.e., pierced with a nail, hit with a hammer,
stepped on). Damaged battery packs should be returned to service center for recycling.
WARNING:
Fire hazard. Do not store or carry battery so that metal objects can
contact exposed battery terminals. For example, do not place battery in aprons,
pockets, tool boxes, product kit boxes, drawers, etc., with loose nails, screws, keys, etc.
Transporting batteries can possibly cause fires if the battery terminals inadvertently
come in contact with conductive materials such as keys, coins, hand tools and the
like. The US Department of Transportation Hazardous Material Regulations (HMR)
actually prohibit transporting batteries in commerce or on airplanes (i.e., packed in
suitcases and carry-on luggage) UNLESS they are properly protected from short circuits.
So when transporting individual batteries, make sure that the battery terminals are
protected and well insulated from materials that could contact them and cause a short
circuit. NOTE: Batteries should not be put in checked baggage.
1. The best storage place is one that is cool and dry away from direct sunlight and

STORAGE RECOMMENDATIONS

excess heat or cold.
2. Long storage will not harm the battery pack or charger.
PORTER-CABLE chargers are designed to charge PORTER-CABLE battery packs in

CHARGING PROCEDURE

30-60 minutes depending on the pack being charged.
1. Plug the charger (11) into an appropriate outlet before inserting the battery pack (9).
2. Insert the battery pack into the charger. (Fig. B)
3. The green LED will flash indicating that the battery
pack is being charged.
4. The completion of charge is indicated by the
green LED remaining on continuously. The battery
pack is fully charged and may be used at this time
or left on the charger.
greatly diminished. For longest battery life, do not discharge batteries fully. It is
Recharge discharged batteries as soon as possible after use or battery life may be
recommended that the batteries be recharged after each use.
All manuals and user guides at all-guides.com
7
B
11
9