Environmental Notice - Braun 3 Serie Mode D'emploi

Alternatively, you may clean the shaver using a brush:
• Switch off the shaver. Remove the shaver Foil & Cutter cassette and tap it
out on a flat surface (picture).
• Using a brush, clean the inner area of the shaver head. However, do not
clean the shaver Foil & Cutter cassette with a brush as this may damage it
(picture).
Keeping your shaver in top shape
Replacement light for shaving parts
To maintain the appliance performing like new, replace the shaver Foil &
Cutter cassette (1), when the replacement light for shaving parts (7) comes
on (after about 18 months) or when worn.
Foil & Cutter cassette: 32S/32B
The replacement light will remind you during the next 7 shaves to replace the
Foil & Cutter cassette. Then the shaver will automatically reset the display.
After you have replaced the Foil & Cutter cassette (1), press the on/off switch
(4) for at least 5 seconds to reset the counter.
While doing so, the replacement light blinks and goes off when the reset is
complete. The manual reset can be done at any time.
Preserving the batteries
In order to maintain the optimum capacity of the rechargeable batteries, the
shaver has to be fully discharged (by shaving) every six months approxima-
tely. Then recharge the shaver to full capacity.

Environmental notice

This appliance contains rechargeable batteries. To protect the
environment, do not dispose of the appliance in the household waste
at the end of its useful life. Disposal can take place at a Braun Service
Center or appropriate collection sites.
Subject to change without notice.
For electric specifications, see printing on the special cord set.
10