Taurus ALPATEC ICE BRISE MINI Mode D'emploi page 4

English
DESK FAN
ICE BRISE MINI
DESCRIPTION
A Body
B Base
C Speed selector
D Holes to mount on the wall
USE AND CARE:
- Fully extend the appliance's power cable before
each use.
- Do not use the appliance if the on/off switch
does not work.
- Do not move the appliance while in use.
- Do not use the appliance if it is tipped up and do
not turn it over.
- Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
- Store this appliance out of reach of children
and/or persons with physical, sensory or redu-
ced mental or lack of experience and knowled-
ge.
- Keep the appliance in a dry, dust-free place, out
of direct sunlight.
- Never leave the appliance connected and unat-
tended if it is not in use. This saves energy and
prolongs the life of the appliance.
INSTALLATION
- Be sure to remove all packaging material from
inside the appliance.
- The appliance should be used with its base
fitted.
MOUNTING ON THE WALL
- Drill two holes in the wall were the fan is going
to be mounted.
- Insert two suitable plugs and screws (not
included). Fasten the screws until leaving a
separation of approximately 1cm between the
head of the screw and the wall.
- Hang the fan from the two holes on the base
(D).
- Fasten the screws again until the fan is totally
fixed.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all products' packaging has
been removed.
USE:
- Extend the cable completely before plugging it
in.
- Connect the appliance to the mains.
- Guide the appliance to direct the flow of air in
the desired direction.
- Turn the appliance on, by selecting the desired
speed using the speed selector (C).
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Select the OFF position (MIN) using the speed
selector (C).
- Unplug the appliance from the mains.
- Clean the appliance.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- If the appliance is not in good condition of clean-
liness, its surface may degrade and inexorably
affect the duration of the appliance's useful life
and could become unsafe to use.