Thermador CHMHP366W Instructions page 8

3. Locate two studs at the mounting location. At the wall
stud locations, measure 1¼'' (32 mm) down from the
ceiling to the middle of the bracket.
4. At the ends of the bracket, select and mark two holes
from the top row. Drill 2 x ¼'' (6,3 mm) Ø mounting
boreholes. Insert two wall anchors (provided).
5. Mount the bracket at the wall studs and wall anchor
locations using ½'' (13 mm) screws (provided). Ensure
that the bracket is level.
6. Insert the complete duct cover at an angle and swivel
toward the wall.
Page. 8
All manuals and user guides at all-guides.com
7. Carefully pull the top part of the extension upwards.
inches (mm)
8. From inside of hood, screw the supplied 5/8'' (16 mm)
Screw the left and right sides of the extension to the
mounting bracket with the supplied stainless screws.
sheet metal screws through the holes on each side
and along the front into bottom of the extension.
Screw quantity is dependent on hood size.