Bissell PET PRO Serie Mode D'emploi page 15

Vacuum Motor Protection
An internal thermal protector has been designed into your vacuum to protect it from
overheating. When the thermal protector activates, the main vacuum motor will stop
operating. If this happens, proceed as follows.
1
Turn vacuum OFF and unplug from electrical outlet.
Check for the source of overheating problem (full
2
dirt cup, dirty filters or, a clog) and fix by following
the maintenance instructions.
3
When the motor cools for approximately
30 minutes, the thermal protector automatically
resets and cleaning may continue. If the vacuum
will not turn on or the thermal protector continues
to activate, your vacuum may need servicing.
Call BISSELL Consumer Care.
NOTE:
The thermal protector controls the main vacuum
motor only, not the brush motor. If the thermal protector
activates, the brush will continue to operate normally;
however, there will be no suction.
All manuals and user guides at all-guides.com
Filter
Filter
Possible areas that could clog.
www.BISSELL.ca
13