Bissell PET PRO Serie Mode D'emploi page 14

Tools
Pet TurboEraser
Tool
Pet Hair
Eraser Tool
TM
Scoop and Sweep
Tool
LED Lighted
Crevice Tool
NOTE: When the small tab on the connection point of Crevice tool comes into contact
with the handle, wand, or hose; that triggers the LED light to come on. When using
with the Wand, be sure it does not pop through the opening at the end of the Wand.
NOTE: The Pet TurboEraser
LED Lighted Crevice Tool each fit any of the above floor cleaning modes; Handle,
Wand, or Hose!
www.BISSELL.ca
12
All manuals and user guides at all-guides.com
Remove tool by pulling away and downwards from vacuum.
For best use, press the brush gently down and pull towards
you in raking motion; too much pressure will cause brush to
stop rotating
TM
Move sweeper from side to side. When you hear
"click", reverse the motion. Clean inside the dirt
bin by pressing on the side tabs gently to open.
You can use a damp cloth or towel to clean excess
dirt and any excess hair. Connect the hose to use
with the vacuum or you can use with the hose
connection.
Attach the Scoop & Sweep tool to the hose to quickly pick-up
messes right into your vacuum. The tools wide suction path
makes it easy to clean up dry pet food and other messes on
the floor. You can also disconnect the Scoop & Sweep tool
from the vacuum for quick dust pan pick-ups in between
vacuuming. Use the brush to sweep debris into the tool.
Pull tab out of battery door area before use to activate.
Connect to handle, wand or hose and the LED Light will auto-
matically come on.
To replace LED battery, unscrew the small screw with a
Phillips head screw driver. Pull cover off to reveal two batteries
(CR1632 3V). Slide and pull out each battery and replace with
new. Be sure the "+" sign on battery is facing out.
Dispose of used battery promptly. Keep away from children.
Do not disassemble and do not dispose of in fire.
Tool, Pet Hair Eraser
TM
Tool, Scoop and Sweep Tool and
TM